DAMPER CASE BASE
Wood can be manufactured from imported MDF or sheet material.
DAMPER BASE CHASSIS
120 N.P.U. It is manufactured from iron and is manufactured from iron and it is produced in accordance with high strength and transportation in all kinds of loads and road conditions.
The base grids can optionally be used for frequent or infrequent printing of 65 grids, 65 N.P.U. iron or 65 N.P.I. iron.
Lower chassis 100 N.P.U. It is manufactured from iron and it is produced in accordance with high strength and transportation in all kinds of load and road conditions.
It can be manufactured from wood, plywood or imported MDF material. Cover sizes and number can be made as desired.
The rear cover damper system can be opened in 3 types. Altan hook system, side opening or frame system can also be manufactured.
Depending on the frame height, the height measurement can be changed, the inserts can be made as hinges or pins.
DAMPER LIFTING SYSTEM
HIDROMAS Brand 116 - 3 - 3075 A Telescopic Cylinder is used.
All moving parts in the grasshopper and arms can be grasörlük and grease lubrication can be done.
HYDRAULIC PUMP TYPE
30-82 DPA Gear type pump is used.
Control system; It is equipped with electric or air control system and control valves can be mounted to the place where the driver can easily reach the location.
Connection plates made of 8-10 mm sheet fastened on the chassis with bolts are welded to the upper damper frame and the vehicle and damper frames are fastened together and the fastening bolts are tightened with bolts. Then all surfaces are painted with primer before cleaning. Places that are necessary will be put in steel paste. The bottom surface of the damper and the subframe are painted in two layers with the paint color used in the vehicle chassis, and the other surfaces of the damper are painted with a two-layer primer.