DAMPER LIFTING SYSTEM
Produced per cylinder telescopic HIDROMAS 175-5-5550 C.
INFORMATION FOR BINS
Chassis, reinforcement of the "I" frame arm made by welding the hub plate in ST-52 on upper and lower blade 12X120 mm ST-52. Chassis arm is supported torsionally connected sleepers. Produced by quality laminated sheets King - Pin in DIN 74080, steel 2 "42 CRMO4 reinforced with profiles King-Pin NP 160 and NP 120 thickness dimensions of 10 mm laminated sheet 1000 x 1000 ST-52.
Each, with a load capacity of 10 tons square drum shape and three axles, are supported by dampers that limit the movement of the axle. Front axle lift system is controlled in the cab. Mechanical foot capacity of 24 tons double circuit is a wide shoe, articulated and telescopic. Bellows and Suspension are Z scissor pneumatic is parabolic.
Braking system is ABS and EBS. Emergency braking system is service bellows Arfesan from 30 to 2 pieces of 30 x 30. With overhead line filter.
With pump control arm, load control valve and automatic tipper. Break ratchets are automatic. Produced by 6 + 1 pieces of duplex tires 385/65 R 22.5 and rim 11.75x22.5. With unique spare wheel support. Toolbox and 1 key unit axle cover are given. Electrical system with 7-pin plug, equipped with 24-volt CEE standard electrical systems and highways.
Brenda rope hook: Forged hooks are played on the sides and the back cover.
Mudguard: Fitted with steel sheet fender by welding in front of and behind suitable rear wheels in vehicle measurements
Toolbox: 1.5 mm steel toolbox is mounted in a suitable place.
Scale: Produced by fixed pipe at appropriate place of Damper.
Strip warning reflectors are assigned back
Any surface of Damper and Finished Tipper is painted with undercoat after cleaning. In case of necessity, will be put in putty steel. The surface of Tipper and Damper will be painted by finishing in the oven after double painting of underlayment.