COVERED DAMPER DORSE

KSD-DRS


General Features

DAMPER CHASSIS
Produced by steel N.P.U. 160 and reinforced by 6mm steel sheet.


BASIS OF THE DAMPER
Produced by 4mm or 5mm steel sheet material and optionally be formed by Hardox 400 or 450 Brinell sheet material.


COVERS
Are made of sheet steel with a thickness of 3 mm or 2.5 mm. The addition of 35 or 40 cm articulated height for good opening and closing. The back cover is made of 2.5 mm or 3 mm sheet metal. The reinforcement profiles provided for resistance of the back cover. The cover can be opened systematically lateral and low with system of hook.


SERIES LIGHT
All lids and additions on request can be made by Docol sheet of 1.2 mm.


DAMPER LIFTING SYSTEM
Lifting System: Produced by Telescopic Sylinder HIDROMAS 175-5-5550 C ..


INFORMATION FOR BINS
Chassis, reinforcement of the "I" section arm made by welding the ST-52 hub plate on upper and lower blade 12X120 mm ST-52. Chassis arm is supported torsionally connected sleepers. Produced by quality laminated sheets King - Pin in DIN 74080, steel 2 "42 CRMO4 reinforced with profiles King-Pin NP 160 and NP 120 thickness dimensions of 10 mm laminated sheet 1000 x 1000 ST-52.
Each, with a load capacity of 10 tons square drum shape and three axles, are supported by dampers that limit the movement of the axle. Front axle lift system is controlled in the cab. Mechanical foot capacity of 24 tons double circuit is a wide shoe, articulated and telescopic. Bellows and Suspension are Z scissor pneumatic is parabolic. Braking system is ABS and EBS. Emergency braking system is service bellows Arfesan from 30 to 2 pieces of 30 x 30. With overhead line filter. With pump control arm, load control valve and automatic tipper. Break ratchets are automatic. Produced by 6 + 1 pieces of duplex tires 385/65 R 22.5 and rim 11.75x22.5. With unique spare wheel support. Toolbox and 1 key unit axle cover are given. Electrical system with 7-pin plug, equipped with 24-volt CEE standard electric systems and motorways.


STANDARD ACCESSORIES
Brenda rope hook: Forged hooks are played on the sides and the back cover.
Mudguard: Fitted with steel sheet mudguard by welding in front of and behind appropriate rear wheels in vehicle measurements
Toolbox: 1.5 mm steel toolbox is mounted in a suitable place.
Scale: Produced by fixed pipe at appropriate place of Damper.
Strip warning reflectors are assigned back


BENCH-DAMPER PAINT
Any surface of Damper and Finished Tipper is painted with undercoat after cleaning. In case of necessity, will be put in putty steel. The surface of Tipper and Damper will be painted by finishing in the oven after double painting of under-neck

HIGH QUALITY
INTERNATIONAL STANDARDS
STRONG NETWORK SERVICE
HIGH PERFORMANCE
LONG-LASTING USE